Dash cover including speedometer offset (suitable for Harley-Davidson models: Nightster from 2022)

The dash cover from Cult-Werk fits all Harley-Davidson Low Rider S, Low Rider ST from year of manufacture 2018 and on Breakout 117 from year of manufacture 2023!The part gives your motorcycle a clean, cool and flatter look on the tank and is needed as a replacement for the original cover if the fittings are relocated to the headlight mask with our offset! This cover is a 100% precisely fitting ABS plastic part - NOT a cheap GRP! All holes and millings are milled on the most modern 5-axis CNC machining centers! When installing models from 2018 to 2020, it is necessary to shorten the holders for the original dash cover and then holes must be drilled - then the cover is included attached to the new bracket supplied (Details can be found in the assembly instructions!). On the newer models there is an additional retaining bracket that is screwed to the original bracket so that the screw connection goes further up! The following surfaces The following variants are available for this dash cover:- Can be painted (Minimal painting effort, because the surface is perfect! The cover is delivered ready for painting and can basically be used immediately be painted!)- Glossy black (No longer needs to be painted - so you save the entire painting costs! Remove the protective film and the cover shines in glossy black!) THE ASSEMBLY INSTRUCTIONS AND THE PARTS REPORT ARE AVAILABLE IN THE "DOWNLOADS" TAB!!!

The Cult-Werk Airbox Cover is suitable for all Harley-Davidson V-Rod & Night Rod Special models. The speedometer was moved to the airbox cover. The entire speedometer unit including the decorative frame is inserted into the airbox cover from above and screwed from the bottom like the original one. Metal holders are screwed into the front and back of the airbox cover so that the airbox cover can be mounted exactly like the original airbox cover! The metal holders are CNC lasered and powder-coated black. The middle part of the airbox cover has been moved downwards so that the original light edges are retained. This means that the airbox cover appears more three-dimensional and significantly more massive. The airbox cover is significantly wider than the original, but is also designed in such a way that it does not protrude over the frame tubes and so that complete turning is possible without the handlebars hitting the airbox cover ! The indicated air inlets give the airbox cover an ingenious look and make the airbox cover extremely complex. Made from ABS plastic, milled on the most modern 5-axis CNC machining centers. Perfect surface, therefore very low painting costs and perfect fit! Made in Austria! The airbox cover comes with the matching air filter covers! The Cult-Werk air filter covers included with the airbox cover are suitable for V-Rod / Night Rod Special year 02, currently. This kit is required for all airbox covers with an integrated speedometer unit. The Cult-Werk air filter cover kit consists of 2 parts, an extremely flat cover for the air filter itself and a very flat air filter box upper part. Made from ABS plastic, milled on the most modern 5-axis CNC machining centers, no adjustment work required. The clips are simply clipped into the new air filter box top - like original. The hole for the sensor is also available (see also pictures below). A supplied adapter piece guarantees easy installation and a perfect hold of the sensor. It is very important that the air filter box is properly closed again, otherwise water and too much air or dust can enter the air filter box, which in turn can cause damage to the engine! THE ASSEMBLY INSTRUCTIONS AND THE PARTS REPORT ARE AVAILABLE IN THE "DOWNLOADS" TAB !!!